Xigmatek Porter CN881 CAM-S8HH1-U01 Manuel D’Utilisation
Codes de produits
CAM-S8HH1-U01
www.xigmatek.com
All contents are Copyright © 2007 XIMATEK Co., Ltd. All rights reserved. Important Notices and Privacy Statement.
2
Porter CN881
Heat-pipe Direct Touch
Universal Retention Module
Link Hook-head screw ① and the clips of MB. Sequentially insert
Washer⑩、Spring 、and Knurled Threaded nut ② to the Hook-head
screw. Washer⑩、Spring 、and Knurled Threaded nut ② to the
Hook-head screw.
Fasten the knurled threaded nut ② to the Hook-head screw ①. Besure
to fasten these 2 nuts at same time to Prevent from damaging chip by
only one side being forced..
According to the picture shown, locate Washers ⑩ (2 pcs)、
Waisted shank ⑧ and HI-head screw ③ onto Al. base. Use
Allen key ⑨ to fasten the HI-head screw ③ in clockwise
direction
Insert Washer ⑩ to P-head screw ⑤. Aim the screw to the holes
of MB and pass through MB from back to front.
According to the picture shown, sequentially insert Washer
⑩、Spring and Hexagon nut ④ into P-head screw ⑤.
Fasten the Hexagon nut ④ to the P-head screw ⑤. Besure
to fasten these 2 nuts at same time to Prevent from damaging
chip by only one being forced.