Philips 1190XD/44 Manuel D’Utilisation

Always remove appliance from canister by lifting 

straight up.  Do not tilt Jet Clean System.

C 

  Pour the Jet Clean Solution (Model HQ200)

into the canister up to a level between the 

two lines located inside the canister.

NOTE:  ONLY USE PHILIPS NORELCO JET 

CLEAN SOLUTION (MODEL HQ200) WITH  

THE  JET CLEAN SYSTEM.  ANY OTHER 

SOLUTION MAY CAUSE DAMAGE  TO  YOUR 

RAZOR. 

C

  ◗ 

When the cleaning solution level drops below  

the minimum level, the ‘cleaning chamber 

empty’ symbol will blink and the razor holder 

will move to the starting position.

 

◗

  If you clean your razor every day, you should 

clean and refill the canister approximately every 

15 days. 

C

   4 

Carefully lower the appliance back onto  

the Jet Clean canister making sure the  

release buttons snap back into place.

When the canister is filled with cleaning solution, 

do not move appliance to prevent leakage. 

28

 

◗

  If the razor does not contain enough power  

for one (1) shave, the Jet Clean Cleaning 

  

System may not work properly.  Charge the 

  

razor in the Jet Clean System before using the  

Jet Clean System to clean your razor.

 

◗

  If you use the razor with shaving foam, quickly 

rinse under hot water before cleaning in the 

Jet Clean System. 

 

  Connect the small plug to the Jet Clean 

System.  Connect the charging plug into 

any 100V to 240V AC outlet.  Use only the 

charging plug provided.

  

.   Place the Jet Clean System on a flat, level 

surface.  Fill the canister with cleaning 

solution (see ‘Preparing Jet Clean System 

For Use’).    

C

 

  Remove protective cap from razor.   

 

 

 

 

C

  

  Place the razor head side down in the 

razor holder with the display facing the 

front of the Jet Clean System.  

 

29