APC NetBotz 320 Rack Appliance NBRK0320E Manuel D’Utilisation

After you have selected a camera from the Camera Pods window and clicked Capture, the Camera 
Capture Settings window opens. Use the Camera Capture Settings window to configure various camera 
and image capture settings. From this window you can configure the following camera and image capture 
settings: 

Brightness

Specifies the brightness of the image captured by the camera. 
The brightness value of the image can be set to values from 0 to 
255. 

Gamma correction

Use the Gamma correction control to adjust the overall 
brightness of the camera image. Gamma correction enables you 
to display captured image more accurately on your computer 
screen. Images which are not properly corrected can look either 
bleached out, or too dark. 

Video Format

Used to specify the format in which video is transmitted by the 
video source. Available selections include: NTSC-M, NTSC-
Japan, PAL-B, PAL-D, PAL-G, PAL-H, PAL-I, PAL-M, PAL-N 
Combination, and SECAM.
Note: This option is available only when configuring Capture 
settings for CCTV Adapter Pods.

Rotate camera image 180 degrees

Check this check box to rotate the image captured by the camera 
180 degrees. This is useful for correctly orienting the image 
captures included in alert notifications and in the Advanced 
View when the appliance has been mounted upside down due to 
installation location restrictions.
Note: This option is not available for use when configuring 
Capture settings for CCTV Adapter Pods.

Flicker filter

Check this check box to minimize image brightness flickering. 
In some situations, typically outdoors or in locations with large 
areas of both brightly lit and low light regions, the brightness 
level of the dark areas in the image can occasionally flicker or 
pulse. Enabling flicker filter will eliminate this flickering. 
Notes: 
Enabling flicker filter can also have a slight impact on the 
number of frames per second at which images are captured and 
displayed. This impact is typically noticeable only at higher 
image capture rates (more than 5 per second).
This option is not available for use when configuring Capture 
settings for CCTV Adapter Pods.

Timestamp

Use this control to specify the location of the timestamp within 
the image capture. Available selections include None (no 
timestamp will be included in the image), Bottom Right, Bottom 
Center, Bottom Left, Top Right, Top Center, and Top Left.