Cisco FL-GK-NEW-3745= Manuel D’Utilisation

2-25

Getting Started with Cisco Hosted Unified Communication Services

OL-15490-01

Chapter 2 Configuring Hosted Unified Communications Services Components Before Loading Bulk Data

Applying Static Configuration to the Cisco PGW

To complete the provisioning required on the Cisco PGW, complete the following
steps.

Procedure

Step 1

Configure the ICCM dial plan.

ICCM is the dial plan which needs to be attached to the HSI trunk groups. This
dial plan will be accessed when calls are passed from the HSIs to the PGW.

To add the ICCM dial plan, use the following parameter:

numan-add:dialplan:custgrpid=”ICCM”, OVERDEC=”YES”

Step 2

Configure the Trunk Group for each HSI.

To add the trunk group, enter the following command:

prov-add:trnkgrp:name="trnkgrp_name",clli="clli_name",svc="signaling_s
vc",type="type",qable=n

For example:

prov-add:trnkgrp:name="1001",clli="hsi",svc="eisup-hsi-ent4a",type="IP

",qable="n"

Step 3

Configure the Routing Trunk Group for each HSI.

To add the routing trunk group, enter the following command:

prov-add:rttrnkgrp:name=”

rttrnkgrp_name”,type=4,reattempts=0,queuing=0

,cutthrough=3,resincperc=0

For example:

prov-add:rttrnkgrp:name=”1001”,type=4,reattempts=0,queuing=0,cutthroug

h=3,resincperc=0

This configuration is required for each HSI.

Step 4

Configure the route to the HSI.

To add the route, enter the following command:

prov-add:rttrnk:weightedTG=”OFF”,name=”route2hsi”,trnkgrpnum=

rttrnkgrp

_name

For example:

prov-add:rttrnk:weightedTG=”OFF”,name=”route2hsi”,trnkgrpnum=1001