Gigaset HC450 S30852-H1799-R101 Manuel D’Utilisation
Codes de produits
S30852-H1799-R101
11
Installing the Gigaset HC450 door intercom system
Gigaset HC450 / en / A31008-M1799-R101-1-7619 / Starting.fm / 13.02.2007
Ve
rs
ion 4,
16
.09.
2005
Connecting entry lighting
If you want to use the bottom doorbell key
to switch on the entry lighting, the light
source must be connected to the control
unit using two cores (see illustration
below). The entry lighting can also be
switched on/off by means of a switch con-
nected in parallel (see sketch, e.g. motion
detector). Alternatively, a sensor input
from a timing circuit can also be
connected.
Connection with the power supply unit
Connect the mains adapter with the plug
on the right-hand side of the control unit
and insert the plug-in power supply unit
into a socket.
Caution:
– The entry light may only be installed by a
qualified electrician.
– Installation work on the control unit must
only be carried out after the current-carry-
ing devices have been disconnected from
the 230 V mains. Please ensure that the
mains voltage is not switched on again
until the installation work has been com-
pleted.
– Stranded conductors must not be used for
the connection and the insulation on the
leads must not be stripped by more than 6
mm. The shrinkage tubes supplied must be
pulled over the two wires (see diagram).
≤ 6 mm
Thermal
shrinkage
tubes
Control unit
Entry lighting
230 V mains
Actuator
Pushbutton
Li
ght
ETS
N
L