Philips Cloud Monitor Base SB4B1927CB SB4B1927CB/00 Manuel D’Utilisation
Codes de produits
SB4B1927CB/00
22
7. Troubleshooting & FAQs
7. Troubleshooting & FAQs
7.1 Troubleshooting
This page deals with problems that can be
corrected by a user. If the problem still persists
after you have tried these solutions, contact
Philips customer service representative.
Common Problems
No Picture (Power LED not lit)
• Make sure the power cord is plugged into
the power outlet and into the back of the
cloud monitor base.
• First, ensure that the power button on the
front of the monitor is in the OFF position,
then press it to the ON position.
No Picture (Power LED is White)
• Make sure the cloud monitor base is
turned on.
• Make sure the signal cable is properly
connected to your cloud monitor base.
• Make sure the monitor cable has no bent
pins on the connect side. If yes, repair or
replace the cable.
• The Energy Saving feature may be activated
Screen says
Attention
Check cable connection
• Make sure the monitor cable is properly
connected to your cloud monitor base.
(Also refer to the Quick Start Guide).
• Check to see if the monitor cable has bent
pins.
• Make sure the cloud monitor base is
turned on.
Visible signs of smoke or sparks
• Do not perform any troubleshooting steps
• Disconnect the monitor from mains power
• Disconnect the monitor from mains power
source immediately for safety
• Contact with Philips customer service
representative immediately.