Cisco Wireless-G Exterior Access Point + Power Over Ethernet WAP200E Manuel D’Utilisation
Codes de produits
WAP200E
PRODUCT DATA
BUSINESS SERIES
Features
NEMA IP53 rated, lightning
protected, weatherproof
housing
protected, weatherproof
housing
10Base-T/100Base-TX
Ethernet Port, Autosensing
half/full duplex and
MDI/MDI-X
Ethernet Port, Autosensing
half/full duplex and
MDI/MDI-X
Built-in 6-dBi directional
antenna with 1x2 MIMO to
increase coverage
antenna with 1x2 MIMO to
increase coverage
Obtains power via 802.3af
Power over Ethernet (PoE)
from a PoE switch or power
injector
Power over Ethernet (PoE)
from a PoE switch or power
injector
Simplified Web interface
for installation and
configuration
for installation and
configuration
Security Features: 802.1X/
RADIUS Authentication
RADIUS Authentication
Supports WEP, WPA-PSK,
WPA2-PSK, WPA-ENT,
WPA2-ENT wireless security
WPA2-PSK, WPA-ENT,
WPA2-ENT wireless security
Supports 4 BSSID and
802.1Q VLAN to SSID
mapping
802.1Q VLAN to SSID
mapping
Supports SNMP and intuitive
Web-based interface
Web-based interface
WMM wireless QoS support
Supports wireless roaming
based on 802.11F (IAPP)
based on 802.11F (IAPP)
Supports AP, Bridge Mode
and Repeater mode
and Repeater mode
Supports wireless security
monitoring (working
together with 200 series
client cards)
monitoring (working
together with 200 series
client cards)
Supports wireless client
isolation
isolation
3 year limited warranty
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Wireless-G Exterior Access Point
with Power over Ethernet
Specifications
Model
WAP200E
Standards
IEEE802.11g, IEEE802.11b, IEEE802.3, IEEE802.3u,
IEEE802.3af (Power over Ethernet), 802.1p (QoS priority), 802.1Q (VLAN),
802.1X (Security Authentication), 802.11i - Ready (Security WPA2),
802.11e - Ready (WMM & U-APSD), 802.11F (Wireless Roaming)
Ports
1 Ethernet, 1 External Antenna
Buttons
Reset
Cabling Type
UTP CAT 5
LEDs
Power, Ethernet, Wireless
Operating System
Linux
Setup/Config
Web UI
Built-In Web UI for Easy Browser-Based Configuration (HTTP/HTTPS)
Static IP
Yes
DHCP Client
Yes
Management
SNMP Version
1, 2 and 2c
Event Logging
Yes
Web F/W Upgrade
Yes
Diags: Flash, etc.
Flash, RAM, LAN, WLAN
Operating Modes
Access Point
Access Point Mode, Point-to-Point Bridge Mode,
Point-to-Multipoint Bridge Mode, Repeater Mode
Wireless
Spec/Modulation
802.11b/DSSS, 802.11g/ODFM
Data Rates
802.11b: 1, 2, 5.5, 11 Mbps; 802.11g: 6, 9, 11, 12, 18, 24, 36, 48, 54 Mbps
Channels
11 North America, 13 Europe (ETSI and Japan)
Auto-Channel Selection
Number of Internal Antennas
2 x 6 dBi (directional)
Antenna Connector Type
Reverse Polarity Female N-Type
Detachable Antenna
Yes (sold separately)
RF Power (EIRP) in dBm
802.11g: Typical – 16.5 dBm, 802.11b: Typical – 17 dBm
Antenna Gain in dBi
Internal Antenna: 6 dBi
Adjustable Power
Yes
Receiver Sensitivity
802.11g: 54 Mbps@ -65 dBm, 802.11b: 11 Mbps@ -85 dBM
Security
WEP/WPA/WPA2
WEP, WPA-PSK, WPA2-PSK, WPA-ENT, WPA2-ENT
Connection Control
Wireless Connection Control: MAC-Based
SSID Broadcast
SSID Broadcast Enable/Disable
802.1X
IEEE 802.1X Support
Wireless Client Isolation
Wireless Client Devices Can Be Isolated from Each Other Either
Within an SSID or Between Two SSIDs. However, Both Isolation Modes Can
Be Enabled at the Same Time.
Web-Based Utility
Access Control
HTTP/HTTPS, Wireless Client Web GUI Access Control
Wireless Security
WEP Bits
64, 128
WPA Bits and Params.
128 - TKIP/AES
WPA2 Bits and Params.
256 - AES
SSID Broadcast On/Off
Yes