Newstar NS431USB 131502 Manuel D’Utilisation

6

NS-231USB/431USB

7

NS-231USB/431USB

Where to Place the KVM Switch:
The NS-231USB/431USB KVM Switch is small, portable, and designed 
to  fit  right  on  the  desktop.  Before  installation,  please  consider  the 
following issue to decide where to place the KVM Switch:

�

t

 

Do you intend to use the manual port selectors for port switching

�

t

 

the length of the cables attached to your keyboard, mouse, and 

     monitor

�

t

 

the location of your computers from your console

�

t

 

the length of the cables you use to connect your computers to the 

     KVM Switch

Cable Distance Requirements:
USB signals can be transmitted up to 15 feet (4.5m) between the KVM 
and  the  computers.  Beyond  15  feet  (4.5m),  the  probability  of  signal 
degradation increase with the distance.

Cautions and Warnings:
Avoid placing cables near machines that create electrical noise such as 
fluorescent lighting, air conditioning equipment, etc.

This section provides you complete instructions for the basic hardware
setup of a single NS-231USB/431USB.

Important Note:
Before  you  begin,  Please  be  sure  to  power  off  all  the  equipment  you 
want to connect to the switch. 

1.Power off all computers.
2.Connect your USB keyboard and mouse directly into the USB 
  keyboard and mouse ports on the back panel of your KVM Switch.

3.Connect the VGA connector (HDDB-15 pin) from your monitor to 
  the console VGA port on the back panel of the Switch.