Brodit ProClip 854814 854814 Fascicule

1.

2.

4.

3.

Please read all of the instructions and look at the pictures before attaching the ProClip.  
 
1. Press the thin end of the enclosed gap opener into the gap between the  
frame surrounding the display and the vent frame panel, to widen the gap. Use the enclosed alcohol pad to clean
the area where the ProClip is to be installed. Peel off the cover of adhesive tape on the ProClip.  
 
2. Insert the lower grooved edge of the ProClip into the seam next to the gap opener. Pull out the gap opener.  
 
3. Using your thumb under the lower part of the ProClip and your fingers on the upper part of the ProClip, flex the
ProClip so the top angled edge goes into the seam between the inner vent and upper vent frame panel. You
might need to wiggle the ProClip a little to get the angled edge into the seam as it is a tight upper seam. Listen for
the ProClip to click into place.  
 
4. The ProClip is in place.