Chief KPP110B Manuel D’Utilisation

Installation Instructions

Model: K-Series

Two installation options exist:

•

Edge Installation

•

Hole (Grommet) Installation; requires 3/8" to 3"
diameter hole and access to the bottom of the
desk

1.

Verify that you have the following parts:

2.

Determine approximate location for mount keeping in
mind display size, extension, height adjustment (if
applicable), and pitch/roll requirements.

3.

Peel backing from adhesive bumpers (40) and attach
to bottom of mount (10) (See Figure 4).

NOTE: One extra bumper (40) included for convenience.

EDGE INSTALLATION
IMPORTANT ! : IF you will be installing a SINGLE
display (including KCY-210/-220) with RECESSED
mounting holes, then proceed to "DISPLAY
INSTALLATION" before continuing with this mount
installation procedure.

NOTE: Bracket (20) and screw (30) are not used in this

installation.

1.

Slip mount (10) over edge of desk so that clamp fully
contacts desk edge.  Using 3/16" hex key, securely
tighten clamp adjustment screw (See Figure 5).

2.

If you are installing:

•

SINGLE display with RECESSED mounting
holes: Proceed to "CABLE MANAGEMENT."

•

KCY-210/-220: Proceed to "MULTI-DUAL ARM
ASSEMBLY."

•

ALL other display configurations: Proceed to
"DISPLAY INSTALLATION."

1.

Using 2.5mm hex key, remove and retain baseplate
and three attach screws from bottom of mount (10)
(See Figure 6).

2.

Using 3/16" hex key, remove clamp adjustment
screw, washer, and clamp (See Figure 7).  Retain
clamp adjustment screw and washer for later use.

NOTE: Clamp will not be used for Hole (Grommet)

Installation.

10

MOUNT, Desk, K-Series

1

20

BRACKET, Grommet

1

30

SCREW, Button Head Cap, 5/16"-18 x 4"

1

40

BUMPER, Adhesive

6

10

40
(5 places)

10

Clamp Adjustment
Screw

Edge

Clamp

of Desk

Baseplate

Attach Screws
(3 places)

10

Baseplate
Nut