Rigol Probe scoop-proof 7 MHz, 150 MHz 1:1, 10:1 300 V RP2200 RP2200 Fiche De Données
Codes de produits
RP2200
1X: DC~7MHz
10X: DC~150MHz
10X: DC~150MHz
1X: 50ns
10X: 2.3ns
10X: 2.3ns
CAT II: IEC Measurement Category II. Inputs may be connected to mains ( up to 300 VAC)
under Category II overvoltage conditions.
under Category II overvoltage conditions.
Cable Length
Ground Alligator Clip
©
2013 RIGOL Technologies, Inc. All Rights Reserved.
1X: 1M
2
Ω
Ω ± %Ω
10X: 10MΩ ±2%
1X: 100pF
20pF
±
10X: 17pF±5pF
1X:
CAT II 150V AC
10X: CAT II 300V AC
Frequency Compensation
Before taking any measurements using a probe first check the
compensation of the probe and adjust it to match the channel
inputs.
Before taking any measurements using a probe first check the
compensation of the probe and adjust it to match the channel
inputs.
-
.
,
Generally, the oscilloscope provides a calibration signal output
terminal at the front panel. Connect the probe to the signal output
terminal to display a square waveform on the oscilloscope and set the
probe attenuation to 10X.Adjust trimmer until seeing flat top square
wave on the display
terminal to display a square waveform on the oscilloscope and set the
probe attenuation to 10X.Adjust trimmer until seeing flat top square
wave on the display
Hook Tip
Maker Rings( yellow
)
, Pink,
light blue and dark blue
联系我们Contact Us
E- mail: service@ rigol. com
Website: www.rigol.com
S M1 0 2 0 0 0 2 6 9 4
注:仅适用 于RP2200单条装
Note: Be applies to the package with only one RP2200
Note: Be applies to the package with only one RP2200