Lecroy WSXS-SPIBUS TD WSXS-SPIBUS TD trigger and decoder extension Compatible with LeCroy WaveSurfer® oscilloscopes. WSXS-SPIBUS TD Manuel D’Utilisation
Codes de produits
WSXS-SPIBUS TD
Operator's Manual
919586 RevA
147
Payload
Data - Bits 29 - 11.
TAIL-OF-BURST
Bit Rate/Msg
Status
Attributes
Note: Specifications are subject to change without notice.
MIPI M-PHY Decode Table Column Details
M-PHY table column values available include the following:
Make selections as desired. You can also set a BitRate Tolerance percentage or touch the Default button to load
the preset selections. Touch the Close button when finished.
the preset selections. Touch the Close button when finished.
See Protocol Results Table (on page 19) for general information about the Table display.
After setting up your M-PHY decode and checking the View Table checkbox, the table should be shown on the
display grid.
display grid.
Note: After touching the View Table checkbox, touch the Close button at the upper-right portion of the
Decode Setup dialog to maximize the display grid area.
Decode Setup dialog to maximize the display grid area.
E
XPORTING
T
ABLE
D
ATA
You can also Exported your table data as a .CSV file. Touch the Export Table button on the Decode Setup...
dialog and follow the procedure explained in the Using The D Supported Protocol Toolsets (on page 14) topic.
dialog and follow the procedure explained in the Using The D Supported Protocol Toolsets (on page 14) topic.