Lecroy WSXS-SPIBUS TD WSXS-SPIBUS TD trigger and decoder extension Compatible with LeCroy WaveSurfer® oscilloscopes. WSXS-SPIBUS TD Manuel D’Utilisation
Codes de produits
WSXS-SPIBUS TD
Serial Data Debug Solutions
176
919586 RevA
SATA Decode Setup Detail
For general information about using controls shown on the main Serial Decode dialog, refer to Accessing The D
and TD Supported Protocol Toolsets (on page 13).
and TD Supported Protocol Toolsets (on page 13).
SATAD
ECODER AND
E
XPORTER
R
IGHT
-H
AND
D
IALOGS
Access the Serial Decode dialog by touching Analysis → Serial Decode on the menu bar.
Touch the corresponding Setup... button for your decode. The Decode Setup... along with the SATADecoder
right-hand dialog is shown.
right-hand dialog is shown.
SATADecoder Right-Hand Dialog
The SATADecoder right-hand dialog provides detailed controls and setup conditions as follows:
Select a Speed value from 1.5, 3.0, and 6.0 Gbps choices.
Configure the Probe Selection control based on whether you're using One Differential Probe or Two
Single Ended Probes.
Single Ended Probes.
Mark the Detect OOB checkbox as desired.
Note: As indicated on the dialog, since OOB detection is time consuming, it's best to only use if truly
necessary.
necessary.
SATA Protocol Exporter Right-Hand Dialog
The SATA Protocol Exporter right-hand dialog provides detailed controls for synchronizing and sending your
data to the Protocol Analyzer.
data to the Protocol Analyzer.