Perfectpro Bathroom Radio, Black RB1 Fiche De Données

  

The Loudness function enables to get compensation on lower and higher frequency. 

The effect will be more audible when the radio is in a lower volume level (Dynamic 

Loudness).

1.  Press the Loudness button to enable the loudness, the display shows “Loudness  

 On”.

2.  Press the Loudness button again to disable the loudness, the display shows  

 

“Loudness Off”.

The radio can be configured to a different language.

1.  Press the On/Off button to turn on the radio.

2.  Press the Menu button, and then rotate the Tuning knob until the display shows  

 “System”.

3.  Press the Tuning knob; rotate the Tuning knob until the display shows “Language”.

4.  Press the Tuning knob to enter the language adjustment menu.

5.  Rotate the Tuning knob until the desired language appears on the display (default  

 

is English).

6.  Press the Tuning knob to confirm your choice. The display will change to the

 

chosen language.

The software display cannot be altered and is just for your reference. You can only view 

the software version in DAB and FM mode.

1.  Press the On/Off button to switch on the radio.

2.  Press the Source button to select FM or DAB mode. 

3.  Press the Menu button until the display shows “Full Scan” , and then rotate the  

 

Tuning knob until the display shows “System”.

4.  Press the Tuning knob; rotate the Tuning knob until the display shows “SW  

 version”.

5.  Press the Tuning knob to view the software version.

6.  Press the Tuning knob again to return to the normal radio display.

Notes: USB socket inside battery compartment is for upgrading the software of the 

device.

  

If the radio fails to operate correctly, or some digits on the display are missing or 

incomplete, carry out the following procedure.

1.  Press the On/Off button to switch on the radio.

2.  Press the Menu button, 

3.  Rotate the Tuning knob until the display shows “System”. Press the Tuning knob. 

4.  Rotate the Tuning knob until the display shows “Factory reset”. Press the Tuning  

 knob.

5.  Rotate the Tuning knob to select between “Yes” or “No”. 

 

Select “Yes” if you wish to reset the radio, otherwise, select “No”.

6.  Press the Tuning knob to cause the factory reset.

7.  A full reset will be performed. All presets and the station list will be erased.  All  

 

settings will be set to the default values. 

 

The display will show “WELCOME TO DIGITAL RADIO” for a few seconds, and then 

 

the radio will automatically perform an auto scan of the Band III DAB channels and  

 

the FM band, the display will show “ATS setting”.

In case of malfunction due to electrostatic discharge; reset the product as above to 

resume normal operation. If you are not able to perform the reset operation as above, 

remove and reconnect the power supply.

G B