Nkk Switches Rotary switch 5 Vdc 0.1 A Switch postions 16 NDFR16H 1 pc(s) NDFR16H Fiche De Données
Codes de produits
NDFR16H
Series ND
8mm Process Sealed DIP Rotaries
www.nkk.com
G34
Indicators
Accessories
Supplement
Tactiles
Keylocks
Pushbuttons
Illuminated PB
Slides
Programmable
Rockers
Touch
Tilt
Toggles
G
Rotaries
Electrical Capacity (Resistive Load)
Switching Rating:
100mA @ 5V DC
Nonswitching Rating: 100mA @ 50V DC
Other Ratings
Contact Resistance: 80 milliohms maximum for circuit; 30 milliohms maximum for contact point
Insulation Resistance:
1,000 megohms minimum @ 250V DC
Dielectric Strength:
250V AC minimum for 1 minute minimum
Mechanical Life:
20,000 detent operations minimum
Electrical Life:
20,000 detent operations minimum
Notes: A detent operation is one actuator position operation or stepping.
20,000 detent operations = 1,250 cycles for hexadecimal devices or 2,000 cycles for decimal
devices. A cycle is one 360° rotation.
Nominal Operating Torque: 0.006Nm
Contact Timing:
Nonshorting (break-before-make)
Materials & Finishes
Actuator:
Glass fiber reinforced polyamide
Housing:
Glass fiber reinforced polyamide (UL94V-0)
O-ring:
Nitrile butadiene rubber
Base:
Glass fiber reinforced polyamide (UL94V-0)
Movable Contact: Beryllium copper with gold plating
Stationary Contacts: Brass with gold plating
Terminals:
Brass with gold plating
Environmental Data
Operating Temperature Range: –25°C through +75°C (–13°F through +167°F)
Humidity: 90 ~ 95% humidity for 96 hours @ 40°C (104°F)
Vibration:
10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range
& returning in 1 minute; 3 right angled directions for 2 hours
Shock:
50G (490m/s
2
) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)
Processing
Soldering: Wave Soldering Recommended: See Profile B in Supplement section.
Note: During Wave Soldering process, set the switch to the following position:
NDFR10, NDFR16, NDKR10, NDKR16: 0 position;
NDFC10, NDKC10: 7 position; NDFC16, NDKC16: F position.
Manual Soldering: See Profile B in Supplement section.
Cleaning:
Automated Cleaning. See Cleaning Specifications in Supplement section.
Standards & Certifications
Flammability Standards: UL94V-0 rated housing & base
The ND Series rotaries have not been tested for UL recognition or CSA certification.
These switches are designed for use in a low-voltage, low-current, logic-level circuit.
When used as intended in a logic-level circuit, the results do not produce hazardous energy.
General
Specifications