Crydom DR10D12 SeriesOne DIN Rail Mount Solid State Relay DR10D12 Fascicule

Crydoms SeriesOne DR Solid State Relays were developed to offer the advantages of Crydom's thermal
management technology in a compact 11 & 18 mm wide IP20 housing with unique integrated heat sink.
The SeriesOne DR provides a quick and easy installation onto any standard 35 mm DIN rail profile
paired with high output power ratings.

Single channel 6 & 12 Amps output power rating
Two independent 6 Amp channels in dual channel versions
Single channel 60 & 100 VDC, 24 to 600 VAC operating voltage ratings
Dual channel 24 to 600 VAC operating voltage ratings
4-32 VDC, 24, 120 & 230 VAC control input options available for single channel versions
4-32 VDC control input for dual channel versions
AC Output versions with Zero Voltage Turn-On for resistive loads and Random Turn-On for inductive loads

Install the relay on the DIN rail (as shown in drawing)
Wire the relay to the input side. 22 AWG minimum,
16 AWG maximum
Wire the relay to the output side. 22 AWG minimum,
14 AWG x 2 or 12 AWG x 1 (standed/solid) maximum

Maximum recommended terminal screw torque
input 4.4 in/lbs (0.5 Nm) & output 7.0 in/lbs (0.8 Nm)

If multiple units are installed be sure to follow
derating curves (reverse side of this sheet)

Please read all installation instructions before using SeriesOne DR SSRs.

1 to 60 VDC
1 to 100 VDC

208 to 265 VAC
90 to 140 VAC

4 to 32 VDC

18 to 36 VAC

48 to 600 VAC

6 Amps

24 to 280 VAC

12 Amps

Zero Voltage Turn-On

Random Turn-On
(AC Output Only)

AC

Output

Only

Required for valid part number

For options only and not required
for valid part number

Not all combinations of ratings are available.

24 to 280 VAC
48 to 600 VAC

4 to 32 VDC

6 Amps

Option
Blank: Zero Voltage Turn-On
R: Random Turn-On

(AC Output Only)

Rev: 072310

To install on DIN rail

To remove from

DIN rail