MPIO ML100 2GB 1001200 Manuel D’Utilisation
Codes de produits
1001200
4
5
Components
Additional components(For example, Necklace and etc) can differ depending on the sales area.
Note:
Actual player may vary slightly from images shown, and subject to change without notice.
Broken components may be purchased separately at MPIO Service Center.
Connecting to your computer
Connect ML100 to the USB connection port on your computer with the USB cable.
- Removing the USB cable, while installing the USB driver or executing a command, may cause malfunction
to your computer.
to your computer.
The USB Driver will be installed with a message indicating “Looking for a New Device”.
The installation screen may not appear.
Note:
MTP (Media Transfer Protocol)
- This mode is for connecting Windows Media Player 10 to ML100 to listen a encoded file as
WMDRM(Windows Media Digital Rights Management) music file.
- If Windows Media Player 10 is installed in your computer which the OS is Windows XP,
you can use the MTP mode. (You have to install Windows Service pack 1 than higher)
- WMDRM is a encoded technology to protect the copyright of music file.
- This mode is for connecting Windows Media Player 10 to ML100 to listen a encoded file as
WMDRM(Windows Media Digital Rights Management) music file.
- If Windows Media Player 10 is installed in your computer which the OS is Windows XP,
you can use the MTP mode. (You have to install Windows Service pack 1 than higher)
- WMDRM is a encoded technology to protect the copyright of music file.
MSC (Mass Storage Class)
- ML100 can be used as a removable disk in this mode, regardless of the operating system
you use.
- Install the USB driver first and connect ML100 to your conputer, if you are using Windows 98SE.
To install the USB driver manually, please refer to “Installing USB Driver Manually”(page5).
To switch between MTP and MSC modes
- While the computer and ML100 are connected, press the lever to switch between MTP and
MSC modes.
Installing USB Driver Manually
Please refer to the below only if ML100 is not plugged with Windows 98SE.
Connect ML100 with your computer with the USB cable.
When Add New Hardware Wizard window appears on the screen,
click the [Next] button.
Check “Search for the driver for your device”, click the [Next] button.
Insert the CD included in the package into the CD-ROM, check CD-ROM DRIVE and
click the [Next] button.
When the driver installation is completed, an “Installation complete” window will
appear on the screen. Then, click the [Finish] button.
click the [Next] button.
Check “Search for the driver for your device”, click the [Next] button.
Insert the CD included in the package into the CD-ROM, check CD-ROM DRIVE and
click the [Next] button.
When the driver installation is completed, an “Installation complete” window will
appear on the screen. Then, click the [Finish] button.
Go to the following destination to confirm that the installation was completed successfully.
Windows 98SE :
Windows 98SE :
[Control Panel]
→ [Systems] → [Device Manager] → [Hard Drive] → MPIO ML100 USB Device
Note:
In Windows 98SE, the program must be installed to use ML100 as a removable disk.
Please install the USB drivers before use.
ML100
Earphones
USB Cable
Utility CD
User Guide
Instructions
2
1
1
2
4
3
Warranty
Battery (AAA)
Necklace