C&E FS20 Wireless transmitter unit FS20 S4UB 4-channel Max. range (open field) 50 m 57125 Fiche De Données

Address group

Subaddress

Single address

44

44

Function group address

44

44

Local master address

44

44

Global master address

44

44

44

= This value must be set to ‘44’.

44

= This value must not be set to ‘44’.

Possible values are:

11, 12, 13, 14, 21, 22, 23, 24, 31, 32, 33, 34, 41, 42, 43

Every receiver can be assigned one address from each of the four address types (single
address, function group address, local master address, global master address).

This means that each receiver can respond to up to four different addresses, but only ever to
one address per address type.



If you need a receiver to respond to more than one transmitter, you can program

the transmitters to the same address or, if different transmitter address types
have been set, you can program the receiver consecutively to these different
addresses.

The individual address types have the following function:

Each receiver should be set to a single address so that it can be controlled separately.

Several receivers are defined as a functional unit by being assigned to a function group
address. If, for example, all the lamps in a house are assigned to a function group, then all
the lamps in the entire house can be switched on or off by pressing one button.

Several receivers are spatially defined as one unit and controlled via the local master
address. If, for example, all the receivers in a room are each allocated to a local master
address, then all you need to do is press one button when leaving the room to switch off
all the consumer loads in the room.