Insys ISDN Terminal Adapter 4.0 11-02-01-02-00.015 Manuel D’Utilisation
Codes de produits
11-02-01-02-00.015
8
Operating Manual INSYS ISDN TA 4.0
Version 2.02 – 01.04
Please disconnect the connection to the phone line immediately in case of incorrect or
irregular behavior of the INSYS ISDN TA. Please refer to your service partner in such
cases. In order to preserve your guarantee, please do not open or perform any opera-
tion on the INSYS ISDN TA.
4.
irregular behavior of the INSYS ISDN TA. Please refer to your service partner in such
cases. In order to preserve your guarantee, please do not open or perform any opera-
tion on the INSYS ISDN TA.
4.
Connecting PC/terminal
Plug the enclosed RS 232 interface cable into the housing front and connect to
PC/terminal.
PC/terminal.
5.
Checking successful installation:
This short test takes place via your terminal program (HyperTerminal). Enter the
command AT and press Enter. If OK appears on your screen the INSYS ISDN TA has
been installed successfully.
command AT and press Enter. If OK appears on your screen the INSYS ISDN TA has
been installed successfully.
6.
Perform a connection set-up:
o
Dial by ATD one of the following numbers (for PABXs, which require a “0” for
connection set-up, replace ATD by ATX3D):
HDLC protocol (ATB3): 010190/1929 (enter ATD0101901929)
X.75 protocol (ATB10): 040/89088291 (enter ATD04089088291)
connection set-up, replace ATD by ATX3D):
HDLC protocol (ATB3): 010190/1929 (enter ATD0101901929)
X.75 protocol (ATB10): 040/89088291 (enter ATD04089088291)
o
Off-Hook LED lights up
o
ISDN TA dials
o
After max. 1 minute, the message CONNECT appears.