Cisco Aironet Converter Clip for Channel Grid Suspended Ceilings AIR-ACC-CLIP-20= Manuel D’Utilisation
Codes de produits
AIR-ACC-CLIP-20=
R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
4
Cisco Aironet Converter Clip for Channel Grid Suspended Ceilings (AIR-ACC-CLIP-20)
78-18348-01
Mounting an 1130 Series Access Point
Figure 3
Disassembling the Converter Clip
Step 7
Position both parts of the converter clip on the channel, one part on one side and the other on the opposite
side.
side.
a.
Make sure the ON arrows on the converter clip are pointing towards each other as shown in
.
The OFF arrows will point away from each other.
Step 8
Squeeze the two parts together by pushing on its ON tabs with your thumb and forefinger until they snap
together.
together.
Step 9
Install the other converter clip.
Step 10
Position the converter clips so that each one is centered over the index marks you made in Step 3.
Step 11
Use a small standard screwdriver to tighten the two set screws on the converter clips and secure it to the
channel. Do not overtighten the set screws.
channel. Do not overtighten the set screws.
Step 12
Align the antenna E-Z clips with the slots on the converter clips.
Step 13
Insert the E-Z clips into the converter clip slots and push the clips into the slots until they will go no
further.
further.
Step 14
Connect the antenna cable to the access point or extender cables.
Step 15
Lower the ceiling tiles onto the channel. If you removed the tiles, replace them.
Mounting an 1130 Series Access Point
Mounting an 1130 series access point on a channel grid suspended ceiling requires two converter clips,
the access point mounting plate and the access point adjustable mounting bracket. The converter clips
are used to attach the adjustable mounting bracket to the channel. The access point mounting plate is
attached to the adjustable mounting bracket and the access point is attached to the mounting plate.
the access point mounting plate and the access point adjustable mounting bracket. The converter clips
are used to attach the adjustable mounting bracket to the channel. The access point mounting plate is
attached to the adjustable mounting bracket and the access point is attached to the mounting plate.
Follow these steps to mount the access point to a suspended ceiling channel.
Step 1
Identify the location where you intend to mount the access point.
Step 2
Raise the ceiling tiles on both sides of the channel. If desired, you can remove the tiles.
230322
1
1
OFF
OFF
ON
ON
OFF
OFF
ON
ON