Jeti 4-channel receiver 2.4 GHz FHSS with Connector system JR 80001221 Manuel D’Utilisation
Codes de produits
80001221
computer radio control system
EN
mode (see point 4.1.1). Wireless connection is only possible when a
receiver is in“Normal“ mode (MeasureOrSetting->Main Setting -
>Rx mode: Normal).
receiver is in“Normal“ mode (MeasureOrSetting->Main Setting -
>Rx mode: Normal).
The JETIBOX can be disconnected only after you disconnect the
receiver voltage supply. You may monitor the on board state of
your receiver during your model‘s operation. Pay particular
attention, of course, to your setup work. While it is possible, we do
not recommend changing setup parameters during model
operation. Set-up work should be only done if there is no danger
of damaging the model or injuring persons. For safety reasons
prevent motor activation or remove the propeller!
receiver voltage supply. You may monitor the on board state of
your receiver during your model‘s operation. Pay particular
attention, of course, to your setup work. While it is possible, we do
not recommend changing setup parameters during model
operation. Set-up work should be only done if there is no danger
of damaging the model or injuring persons. For safety reasons
prevent motor activation or remove the propeller!
5.2. Receiver Set-up via the Transmitter DC/DS
Please see information concerning receiver set-up via transmitters
in the DC/DS transmitter instruction manual. You can find the
DC/DS instructions on the manufacturer‘s website.
in the DC/DS transmitter instruction manual. You can find the
DC/DS instructions on the manufacturer‘s website.