Pietsch BikeLogger L 78033-BL-01L Fiche De Données
Codes de produits
78033-BL-01L
Tools
Required
1. 2,5mm Allen key
2. Insulation strippers (or scissors/knife)
3. Crimp plier (or regular flat nose pliers)
4. Hot air gun (or lighter)
2. Insulation strippers (or scissors/knife)
3. Crimp plier (or regular flat nose pliers)
4. Hot air gun (or lighter)
Optional
Busch& Müller headlight bracket - 474 DL or 475D
Extra cable (when extension necessary)
Soldering iron (for cable extension)
Wire cutters
Installation Instructions
1. Using the wire cutters, cut a section of the lamp cable
extending from the hub dynamo to the headlight. If possible,
level this with the headlight frame, cutting the cable as close
to its bracket as possible.
extending from the hub dynamo to the headlight. If possible,
level this with the headlight frame, cutting the cable as close
to its bracket as possible.
! Please pay attention to the length of cable which
requires cutting – cable may have to be extended to
accommodate for installation.
! If lighting is originally connected via a coaxial cable
instead of a two-wire cable, please see our additional
notes on
requires cutting – cable may have to be extended to
accommodate for installation.
! If lighting is originally connected via a coaxial cable
instead of a two-wire cable, please see our additional
notes on
2. Unravel the cable and remove insulation with your
available tool.
3. Twist the two pairs of exposed cable-ends together
correspondingly.