Texas Instruments High Performance Frequency Synthesizer System with Integrated VCO LMX25313010EVAL/NOPB LMX25313010EVAL/NOPB Fiche De Données
Codes de produits
LMX25313010EVAL/NOPB
L M X 2 5 3 1 L Q 3 0 1 0 E E V A L U A T I O N B O A R D O P E R A T I N G I N S T R U C T I O N S
Loop Filter
Loop Bandwidth
13.8 kHz
K
φ
1440 uA (16X)
Phase Margin
54.5 °
F
PD
10 MHz
Crystal Frequency
10 MHz
Output Frequency
2910 to 3132 MHz (DIV2=0)
1455 to 1566 MHz (DIV2=1)
Supply Voltage
3.0 Volts
VCO Gain
13 to 29 MHz/Volt
VCO
CPout
op
en
100 nF
1K
Ω
100 pF
100 pF
20 KΩ
20 KΩ
Vtune
Quick Setup
• Install the CodeLoader software which is available at
.
• Attach the parallel cable or USB <--> uWire cable to the computer and the evaluation board.
• Connect 3.0 volts to the Vcc connector.
• Connect
the
Fout connector to a spectrum analyzer or phase noise analyzer.
• Connect a clean 10 MHz source to the OSCin pin. Typically, the 10 MHz output from the back
of the RF test equipment is a good source. Signal generators tend to be very noisy and should
be used with caution. If a signal generator is used, the signal generator phase noise
contribution can be reduced by setting the signal to 80 MHz and dividing this down to a phase
detector frequency of 10 MHz.
be used with caution. If a signal generator is used, the signal generator phase noise
contribution can be reduced by setting the signal to 80 MHz and dividing this down to a phase
detector frequency of 10 MHz.
• Set up the CodeLoader software.
o
Select the proper part from the menu as Select Part->PLL+VCO->LMX2531LQ3010E
o
Select the proper mode from the Mode menu.
o
Load the part by pressing Ctrl+L or selecting Keyboard Controls->Load Device from
the menu.
• It is recommended to ensure proper communication with the device.
o
Click the REG_RST bit on the bits/pins page and observe the current go to 0 mA.
o
Unclick the REG_RST bit AND press Ctrl+L. The current should be approximately
35 mA.
o
o
If device does not respond to this, consult the troubleshooting section.
3