Texas Instruments 150-mA, Low-Dropout Regulator Evaluation Module TLV71312PEVM-171 TLV71312PEVM-171 Fiche De Données
Codes de produits
TLV71312PEVM-171
V
- 2 V/DIV
IN
EN - 2 V/DIV
V
- 1 V/DIV
OUT
I
- 100 mA/DIV
OUT
time - 0.2 mS/DIV
Operation
2.2
Soldering Guidelines
Any solder re-work to modify the EVM for the purpose of repair or other application reasons must be
performed using a hot-air system to avoid damaging the integrated circuit (IC).
performed using a hot-air system to avoid damaging the integrated circuit (IC).
2.3
Equipment Interconnect
•
Set the input power supply to 5.5 V(max). Turn the power supply off. Connect the positive voltage lead
from input power supply to V
from input power supply to V
IN
, at the J1 connector of the EVM. Connect the ground lead from the input
power supply to GND at the J2 connector of the EVM.
•
Connect a 0–150-mA load between the output, OUT, at connector J3, and ground, GND, at connector
J4.
J4.
•
Disable the output by jumping JP1, the EN pin to the OFF pin.
3
Operation
•
Turn on the power supply.
•
Enable the output by jumping JP1, the EN pin to the ON pin.
•
Vary the respective load and input voltage as necessary for test purposes.
4
Test Results
This section provides typical performance waveforms for the EVM. Actual performance data can be
affected by measurement techniques and environmental variables; therefore, these curves are presented
for reference and may differ from actual results obtained by some users.
affected by measurement techniques and environmental variables; therefore, these curves are presented
for reference and may differ from actual results obtained by some users.
4.1
Turn-on Waveform
shows the turn-on characteristic where 3 V is applied to V
IN
. The output drives a 12-
Ω
load (full
load).
Figure 1. Turn-on Waveforms into Full Load (12
Ω
) of the TLV71318PEVM-171
4.2
Turn-off Waveform
shows the turn-off characteristic where 3 V is applied to V
IN
. The output drives a 12-
Ω
load.
2
TLV713xxPEVM-171 Evaluation Module
SLVU771 – September 2012
Copyright © 2012, Texas Instruments Incorporated