Texas Instruments TSW4806EVM: Low Cost Programmable Clock Source TSW4806EVM TSW4806EVM Fiche De Données
![Texas Instruments](https://files.manualsbrain.com/attachments/b46f99d826b2b0e0e5f558c5fb6483942eb9216b/common/fit/150/50/c15ea36eb1fb1cce99a3b94668675bfc78ce832d8d727d9a7bb51a125510/brand_logo.gif)
Codes de produits
TSW4806EVM
EEPROM
Figure 6. Clock Divider Settings
Note that clock pairs share the same dividers. This example also shows that Clocks 1, 4, 7, 8 and 9 are
powered down. These outputs are not used on the EVM.
powered down. These outputs are not used on the EVM.
4
EEPROM
Saving the custom configuration settings from the TSW4806 GUI (
) is possible with the on-board
EEPROM. With the settings saved, the LMK04806 is programmed without using the GUI. The EEPROM
saves up to eight user-defined settings, starting from address 8. The EVM comes from the factory with two
pre-loaded configurations stored in address locations 0 and 1.
saves up to eight user-defined settings, starting from address 8. The EVM comes from the factory with two
pre-loaded configurations stored in address locations 0 and 1.
4.1
Writing to the EEPROM
Write to the EEPROM with the following steps:
(a) Configure the GUI to the desired setting.
(b) Select an address from 8 to 15 in the EEPROM section of the GUI.
(c) When the Write button is pushed, the current GUI settings are saved to the selected EEPROM
address.
Note: Read from the EEPROM by selecting the desired read address and pressing the Read button.
8
TSW4806EVM
SLAU454 – July 2012
Copyright © 2012, Texas Instruments Incorporated