Texas Instruments AFE5809 Evaluation Module AFE5809EVM AFE5809EVM Fiche De Données
Codes de produits
AFE5809EVM
Hardware Setup, CW Mode
9.2
Step 2: Apply Input and Observe Outputs
•
Apply an analog signal (2.51 M, –10 dBm) to any analog input SMA.
•
The CW outputs (J12, J13) display the frequency I and Q signals at 10 kHz as shown in
The GUI Gain Control Feedback Resistor can be used to vary the amplitude of the outputs.
Figure 21. CW Outputs
22
AFE5809EVM Evaluation Module
SLOU338A – October 2012 – Revised November 2012
Copyright © 2012, Texas Instruments Incorporated