Texas Instruments AFE5809 Evaluation Module AFE5809EVM AFE5809EVM Fiche De Données
Codes de produits
AFE5809EVM
Board Configuration
11
Board Configuration
11.1 I/O, Power Supply, and USB
Figure 26. I/O, PWR, and USB Connector
Table 2. I/O, Power, and USB
Connector
Description
J1 through J8
Analog Input signals for Ch1 through Ch8. Connect to a signal generator. A bandpass filter must be applied
between the generator and the SMA to get a better result. (See
between the generator and the SMA to get a better result. (See
.)
P1/JP6
P1 is the +5-V and –5-V power supply connector. JP6 is the test point for +5-V/-5-V power supply.
JP3
Onboard 5-V enable. The configuration must be set up as shown in
in order to use onboard 5-V
supply.
TP-5V
-5-V supply test point
+5VA
+5-V supply test point
JP1
Onboard +1.8-V enable. The configuration must be set up as shown in
in order to use the onboard
+1.8 V.
JP2
Onboard 3.3-VA enable. The configuration must be set up as shown in
in order to use the onboard
3.3 V.
TP18VD
+1.8-VD supply test point
27
SLOU338A – October 2012 – Revised November 2012
AFE5809EVM Evaluation Module
Copyright © 2012, Texas Instruments Incorporated