Texas Instruments AFE5807 Evaluation Module AFE5807EVM AFE5807EVM Fiche De Données
Codes de produits
AFE5807EVM
Hardware Setup, CW Mode
9.2
Step 2: Apply input and observe outputs.
•
Apply an analog signal (2.51 M,
–
10 dBm) to any analog input SMA.
•
The CW outputs (J12, J13) display the frequency I and Q signals at 10 kHz as shown in
. The
GUI Gain Control Feedback Resistor can be used to vary the amplitude of the outputs.
Figure 6. CW Outputs
15
SLOU329A
–
November 2011
–
Revised December 2011
AFE5807EVM (Rev E) Evaluation Module
Copyright
©
2011, Texas Instruments Incorporated