C&E Quartz heater 15 m² White RH06 RH06 Fiche De Données

Codes de produits
RH06
Page de 8
Intended use
The heater generates heat via the integrated infrared heater. Two performance levels (400 or 
800 W) can be selected with a rotary knob. The heater is suitable for rooms of about 20 m².
The product may only be used in dry, enclosed rooms.
Any use, other than the one described above, may damage the product. Moreover, this involves 
hazards such as e.g. short circuit, fi re, electric shock, etc. Modifying or rebuilding any part of 
the product is forbidden! 
Always observe the safety instructions included in these operating instructions. Please read the 
operating instructions carefully and keep them.
This product complies with the applicable National and European requirements. All names of 
companies and products are the trademarks of the respective owner. All rights reserved.
Explanation of Symbols, Inscriptions

   This symbol indicates a health hazard, e.g. electric shock.

   The exclamation mark indicates specifi c risks associated with handling, function and 
use. 
  The “Hand” symbol indicates special tips and operating information.
  Never cover the product. There is a risk of fi re!
   The product is only intended to be placed and used in dry and enclosed indoor 
rooms; it must not get damp or wet.
Package Contents
• Heater
• Operating Instructions
Safety Instructions


   The warranty will be void in the event of damage caused by failure to observe 
these safety instructions! We do not assume any liability for any consequen-
tial damage! 
 
 Nor do we assume any liability for material and personal damage caused by 
improper use or non-compliance with the safety instructions! The warranty 
will be void in such cases! 
 
a) In general
 
•  The unauthorised conversion and/or modifi cation of the product is not permitted 
for safety and approval reasons (CE). Do not open/disassemble! Contains no 
customer-serviceable parts.
 
   Maintenance, adjustment or repair work may only be carried out by an expert/
authorised service center which is familiar with the risks involved and the relevant 
regulations.  
 
•   The device is designed according to safety class I. It may only be connected to and 
used through an earthed mains socket.
 
•  The product is not a toy and must be kept out of the reach of children. Be espe-
cially careful if children are around. Children cannot see the danger arising from 
incorrect use of electrical devices. Children might try to push objects through the 
product openings, for example. There is a risk of a life-threatening electric shock! 
Furthermore there is a high risk of personal injury or burns from the hot front side 
or radiation heat!
 
  Install the product so that it cannot be reached by children.
 
•  Do not carelessly leave the packaging material lying around since this may be-
come a dangerous toy for children.
 
•  Handle the product with care, it can be damaged by impacts, blows, or accidental 
drops, even from a low height. 


  b) Installation location
 
•  The product may only be used in dry, closed interior areas, it must not get damp 
or wet! Never set up the product in the direct vicinity of a bathroom, a shower or a 
bathing tub or similar! There is a danger to life through an electric shock!
 
• Do not place the heater directly underneath a wall socket.
 
•  Choose an appropriate mounting place. It must be fi xed, big enough, level, stable 
and far away enough from infl ammable materials and items (i.e. curtains, furniture, 
doors, etc.). Maintain a minimum distance of 1.5 m. Never place the power cord in 
front of the heater.
 
   The heater is only suitable for mounting horizontally, level, even and on a suf-
fi ciently big surface (i.e. fl oor).
 
•   The heater must not be exposed to extreme temperatures, direct sunlight or strong 
vibrations. 
 
•  Never place the heater on an unstable or movable surface. Always place the 
heater in such a way that it cannot tilt or topple over. 
 
   A security switch at the underside will automatically switch off the heater if it is lifted 
off the fl oor or when it tips over. Never block this security switch!
 
   Despite the safety switch there is a risk of fi re if the device tilts/falls over! Further-
more people could be injured, or the device damaged.
 
•  Due to the weight of the heater and the radiating heat, you should never place the 
heater on a valuable fl oor surface without suitable protection. Otherwise it may not 
only cause scratch marks or pressure marks, but also discoulorations due to the 
radiating heat.
 
•  Never use the heating device in any kind of vehicle or similar moving objects or 
spaces; it is only suited for use in buildings.
 
•  Unwind the mains cable completely during operation. The power cable must not 
be pinched or damaged by contact with sharp edges. Do not place any objects on 
the cable, and do not allow it to become kinked. Install the cable where no one 
can stumble over it and the plug is easily accessible. Do not install the mains cable 
under carpets or the like.
 
•  Do not operate the device in environments where there are high levels of dust, 
fl ammable gases, vapours or solvents. There is a danger of fi re and explosion!
 
c) Handling and operation
 
•  Never plug in or unplug the plug-in power unit with damp or wet hands. There is a 
risk of a life-threatening electric shock!
 
•  Never connect the device to the power supply immediately after it has been trans-
gerred from a cold room into a warm one. The condensation that develops in such 
cases could damage the device or cause an electric shock! Allow the heater to 
reach room temperature. Wait until the condensation has evaporated. This might 
take several hours. Only after this should the heater be plugged in to the power 
supply and put into use.
 
• Never operate the heater unsupervised.
 
•  Do not use the heater in connection with an additional timer, a remote switching 
device (e.g.remote controlled power socket) or similar devices, which automati-
cally switch on the heater. Covering the heater or installing it in a wrong location 
may cause a fi re hazard.
 
•  Never connect the heater to an extention cord or a dimmer or something similar. 
Plug it directly into an earthed wall power outlet.
 
•  When using the heater for the fi rst time, hot parts of the case may cause an irritat-
ing odour for a while. If you experience this, ventilate the room where the heater is 
set up. 
 
•  Always pull the mains plug on the gripping surface intended for this purpose. 
Never unplug the mains plug from the mains socket by pulling the cable!
 
•  Unwind the mains cable completely during operation. If the cable is not unwound 
completely, it can cause overheating; danger of fi re!
 
•  Do not use the product when it is damaged (e.g. housing, mains cable). A defec-
tive connecting cable may only be replaced by a specialist. There is a risk of a 
life-threatening electric shock!
 
•  Always pull the mains plug out of the mains socket before cleaning the heater, or 
when the heater is not to be used for a while.
 
•  Always leave suffi cient space (at least 1.5 m) from combustible or fl ammable ma-
terials or objects (curtains, doors, furniture etc.). If the distance is too small, there 
is a risk of fi re. Never operate the heater inside cabinets or other small enclosed 
rooms. Fire hazard!
 
   O P E R A T I N G   I N S T R U C T I O N S   www.conrad.com
Quartz heater 800 W
 Item no. 55 13 10
 Version  09/11