Insys GSM 4.2 LOGO! compact KIT 11-02-01-03-04.004 Manuel D’Utilisation
Codes de produits
11-02-01-03-04.004
INSYS GSM 4.2 LOGO!
Commisioning
Dezember 06
23
3.3.6 Summary of LOGO!-Specific SMS Commands
Command Function
BLOCK<blocknumber1>
[,<blocknumber2>
[,<blocknumber3>]]?
BLOCK<blocknumber1>
[,<blocknumber2>
[,<blocknumber3>]]?
Actual value scan of up to 3 function blocks
on the basis of the block number assigned in
the control program
on the basis of the block number assigned in
the control program
CHKSUM?
Scan of checksum of the control program
running on LOGO!
running on LOGO!
MONITOR?
Scan of current values of PA buffer in the
form of a PA-SMS
form of a PA-SMS
STATUS?
Scan of LOGO! operating status
STATUS=<logo-
status>
status>
Change of LOGO! operating status
Like all other commands from the expanded command set of the INSYS GSM 4.2,
these command entries can also be preceded by AT**. These commands can be
sent not only via SMS but also via a GSM data connection. This requires a change
in the remote configuration mode. In this case, AT** must be prefixed.
these command entries can also be preceded by AT**. These commands can be
sent not only via SMS but also via a GSM data connection. This requires a change
in the remote configuration mode. In this case, AT** must be prefixed.
3.4
New and Expanded Historical Entries
3.4.1 New Historical Entries
Meaning
PLC ERROR
A reply was not received after three
attempts during LOGO!
communication
attempts during LOGO!
communication
SYSTEM
PLC PERIODIC “Periodic PA-SMS” operation is starting
3.4.2 Expanded Historical Entries
Meaning
ALARM START
If a fault message becomes active due
to value monitoring, “PLC CHANGE” is
indicated as a more detailed
description in place of where the
number of pulses and the alarm input
are specified for alarms via the alarm
input.
to value monitoring, “PLC CHANGE” is
indicated as a more detailed
description in place of where the
number of pulses and the alarm input
are specified for alarms via the alarm
input.