Greenlee DML-430A Digital-Multimeter, DMM, 52047808 Fiche De Données
Codes de produits
52047808
*
*
Sampling time of the measurement value is shown on the screen. If the
selected;sampling time of the measurement is 250ms,
If 2 is selected,it is 500ms.If 3 is selected, it is 750ms.If 1 is selected,it is 1 second.
1
Optn
If this key is pressed
measuring type
appears.
,
y using
and
keys measuring type can be adjusted
,
or
B
,
to ac dc
acdc.
Three leds
at the top of the display show measuring type.
Measuring
type
SET
If this key is pressed,
address of the device appears.
Adrs
1
By using
and
keys address of the device can be adjusted between 1-247.
SET
**
If this key is pressed,
sampling time measurement
value appears.
SET
4
Sampling time
measurement value
ACdC
SET
If key
is pressed,it returns to parameter name.
SET
If key
is pressed, it returns to parameter name.
SET
If key
is pressed, it returns to parameter name.
SET
baud
OFF
By using
and
keys, baudrate value of the device can be adjusted to OFF,1200,2400,4800,9600,19200.
SET
If
key is pressed,it returns to parameter name.
(*)
There are only
parameters in the devices those have no relay.
The
and
parameters are only in the devices those have modbus.
(**)
AdrS
baud
,
,
tYPE optn CInp
,
If any key is pressed in 25 seconds or the device is powered down and powered upþ,then it returns to operation mode.
NOTE:
**
If
key is held down while the device is powered up, the
message will appear and the factory settings will be restored.
d.PAr
Means, measured current value is higher than
scale.
maximum
Means, measured current value is lower than
scale.
minimum
ERROR MESSAGES
When this key is pressed,
baudrate is seen.
SET
C.Inp
500
*
When this key is pressed,
measurement input type
s seen.
i
“
”
.
If
nput type
is selected, the measurement terminals 9 and 12 of the terminals must be connected Otherwise the measurement is done incorrectly.
C.Inp
500
If
ý
C np
50
input type “
” is selected, the measurement terminals 10 and 11 of the terminals must be connected.Otherwise the measurement is done incorrectly.
4./4
EPV 41 -
2
A E
Factory settings restored after
;
,
and
are set to “
”
CInp 50 HYSL
HYSU
1.00