Freescale Semiconductor MPC830x PowerQUICC II Pro Processor Evaluation Kit MPC8309-KIT MPC8309-KIT Fiche De Données
Codes de produits
MPC8309-KIT
MPC8309 PowerQUICC II Pro Integrated Communications Processor Family Hardware Specifications, Rev. 2
Freescale Semiconductor
19
Enhanced local bus
7
Enhanced local bus
This section describes the DC and AC electrical specifications for the enhanced local bus interface of the
MPC8309.
MPC8309.
7.1
Enhanced local bus DC electrical characteristics
The following table provides the DC electrical characteristics for the enhanced local bus interface.
7.2
Enhanced local bus AC electrical specifications
The following table describes the general timing parameters of the enhanced local bus interface of
MPC8309.
MPC8309.
Table 17. Enhanced local bus DC electrical characteristics
Parameter
Symbol
Min
Max
Unit
High-level input voltage
V
IH
2
OV
DD
+ 0.3
V
Low-level input voltage
V
IL
–0.3
0.8
V
High-level output voltage, I
OH
= –100
μA
V
OH
OV
DD
– 0.2
—
V
Low-level output voltage, I
OL
= 100
μA
V
OL
—
0.2
V
Input current
I
IN
—
±5
μA
Table 18. Enhanced local bus general timing parameters
Parameter
Symbol
1
Min
Max
Unit
Note
Local bus cycle time
t
LBK
15
—
ns
2
Input setup to local bus clock (LCLK
n)
t
LBIVKH
7
—
ns
3,
4
Input hold from local bus clock (LCLK
n)
t
LBIXKH
1.0
—
ns
3, 4
Local bus clock (LCLK
n) to output valid
t
LBKHOV
—
3
ns
3
Local bus clock (LCLK
n) to output high impedance for LAD/LDP
t
LBKHOZ
—
4
ns
5
LALE output fall to LAD output transition (LATCH hold time)
t
LBOTOT
3
—
ns
—
LALE output rise to LCLK negative edge
t
LALEHOV
—
3
ns
—
LALE output fall to LCLK negative edge
t
LALETOT
–5.0
—
ns
—
Notes
:
1. The symbols used for timing specifications follow the pattern of t
(first two letters of functional block)(signal)(state)(reference)(state)
for
inputs and t
(first two letters of functional block)(reference)(state)(signal)(state)
for outputs. For example, t
LBIXKH1
symbolizes local bus
timing (LB) for the input (I) to go invalid (X) with respect to the time the t
LBK
clock reference (K) goes high (H), in this case for
clock one(1).
2. All timings are in reference to falling edge of LCLK0 (for all outputs and for LGTA and LUPWAIT inputs) or rising edge of
LCLK0 (for all other inputs).
3. All signals are measured from OV
DD
/2 of the rising/falling edge of LCLK0 to 0.4
× OV
DD
of the signal in question for 3.3-V
signaling levels.
4. Input timings are measured at the pin.
5. For purposes of active/float timing measurements, the Hi-Z or off state is defined to be when the total current delivered
5. For purposes of active/float timing measurements, the Hi-Z or off state is defined to be when the total current delivered
through the component pin is less than or equal to the leakage current specification.