Meilhaus Electronic Logian-16 Logic-Analyzer, Logic analyzer Logian-16 Fiche De Données
Codes de produits
Logian-16
Logian-16
User Manual
Logian-16 User
’s Manual
Page 24
the Trigger Level as the voltage level that a trigger source signal must reach
before the trigger circuit initiates a sweep.
before the trigger circuit initiates a sweep.
Tip:
There are four commonly used preset voltages for Trigger Level, TTL,
CMOS (5V), CMOS (3.3V), and ECL. Users also may define their own
voltage from -6V to +6V to fit with their DUT.
Port A represents the pins from A0 ~ A7 on the signal connector of the Logic
Analyzer, and so do Ports B, C and D. The voltage of each port may be
configured independently.
voltage from -6V to +6V to fit with their DUT.
Port A represents the pins from A0 ~ A7 on the signal connector of the Logic
Analyzer, and so do Ports B, C and D. The voltage of each port may be
configured independently.
Fig 2-5
– Trigger Properties Error
Step 3.
Trigger Count.
Type the numbers or select the number from the pull down menu of the Count
on the Tool Bar or Click the pull down menu of the Trigger
Count on the Trigger Properties dialogue as shown in Fig 2-5
The system will be triggered where the Trigger Count is set as shown in
Figs 3-6,3-7 and Fig 3-8.
Figs 3-6,3-7 and Fig 3-8.
Fig 3-6 – Trigger Count Drop down Menu