Philips DIGITAL CAMERA DSC 2000K DSC2000K/00 Manuel D’Utilisation
Codes de produits
DSC2000K/00
Charging/recharging the battery
1
Make sure the camera is turned off.
2
Turn on the PC.
3
Connect the USB cable to the USB port of the PC.
4
Connect the camera USB connector to the USB connector on the docking base.
Push it down gently until it clicks in position.
Push it down gently until it clicks in position.
>
You will hear a low/high beep, the Charge LED starts blinking blue.
The battery will now be charged.
The battery will now be charged.
>
The USB LED slowly blinks red.
When USB connection has been established the USB LED remains lit.
When USB connection has been established the USB LED remains lit.
>
It will take 4 hours to fully recharge the battery.
When the battery is fully recharged the Charge LED will remain lit.
When the battery is fully recharged the Charge LED will remain lit.
Notes!
–
–
When the battery is fully charged you can take hundreds of photos with the flash and over
thousand photos without the flash.
thousand photos without the flash.
–
When the battery is almost empty, ‘
‘ appears on the display and the Power low LED starts
blinking.
–
The camera contains a lithium-polymer battery. These batteries lose their charge even when not
used, so be sure to charge the battery before taking photos.
used, so be sure to charge the battery before taking photos.
–
Turn off the camera when you are not using it.
–
When the camera is connected to the PC, the camera buttons are disabled.
2.0
MEGA
PIXELS
2.0
MEGA
PIXELS
ENGLISH
16