Gigaset E36 HANDGIGAE36 Manuel D’Utilisation
Codes de produits
HANDGIGAE36
14
Appendix
Gigaset E36 / IM1_en / A31008-M1853-R101-2-6Z19 / appendix.fm / 21.05.2007
Ver
si
on 4, 16.
09.20
05
Appendix
Symbols and typographical
conventions used
conventions used
This section explains the meaning of cer-
tain symbols and typographical conven-
tions that are used in this user guide.
~
~
Enter digits or letters.
§Menu§
The display functions cur-
rently in the bottom display
line are shown in reverse
video. Press the relevant dis-
play key to launch the func-
tion.
q
Press the top or bottom of the
control key, for example when
scrolling.
c / Q / P etc.
Press the illustrated key on the
handset.
External Calls
/
Internal Calls
(example)
Select one of the menu func-
tions (
External Calls
or
Internal
Calls
) from the list and
press
§OK§
.
§Menu§
¢
Audio Settings
¢
§OK§
¢
Ringer
Melody
(example)
¢
§OK§
Press
§Menu§
. Select
Audio Set-
tings
using
q and press
§OK§
.
Select
Ringer Melody
using
q
and press
§OK§
.
Care
¤
Wipe the base station and handset with
a damp cloth (do not use solvent) or an
antistatic cloth.
Never use a dry cloth. This can cause
static.
Contact with liquid
If the handset has come into contact with
liquid:
¤
Switch the handset off and remove
the batteries immediately.
¤
Allow the liquid to drain from the
handset.
¤
Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours
(not in a microwave, oven, etc.).
¤
Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will gener-
ally be able to use it again.
Questions and answers
If you have any questions about using
your phone, visit us anytime at www.sie-
table below contains a list of common
problems and possible solutions.
The display is blank.
1. The handset is not switched on.
1. The handset is not switched on.
¥
Press andhold the end call key
a
.
2. The battery is flat.
¥
Charge the battery or replace it
The handset does not respond to a key
press.
The keypad lock is activated.
The keypad lock is activated.
¥
Press and hold the hash key
#
Base
is flashing in the display.
1. The handset is outside the range of the
base station.
¥
Move the handset closer to the base.
2. The base station is not switched on.
¥
Check the base station mains adapter.
Handset does not ring.
The ringtone is switched off.
The ringtone is switched off.
¥
Activate the ringtone (page 12).
!