Fluke 190-102 2-channel hand-held oscilloscope, ScopeMeter® 190 series II, hand-held 4025318 Manuel D’Utilisation
Codes de produits
4025318
A-1
Appendix A
Installing USB Drivers
Introduction
The Fluke 190 Series II ScopeMeter comes with a USB
interface (connector: USB type “B mini”) for
communication with a computer. To be able to
communicate with the instrument, drivers need to be
loaded onto the computer. This document describes how
to install the drivers on a Windows XP computer.
Installing on other Windows versions will be similar.
interface (connector: USB type “B mini”) for
communication with a computer. To be able to
communicate with the instrument, drivers need to be
loaded onto the computer. This document describes how
to install the drivers on a Windows XP computer.
Installing on other Windows versions will be similar.
Drivers for Windows XP, Vista and Win 7 are available
from the Windows Driver Distribution Center, and can be
downloaded automatically if your computer is connected
to the internet.
from the Windows Driver Distribution Center, and can be
downloaded automatically if your computer is connected
to the internet.
The drivers have passed Windows Logo Verification and
are signed by Microsoft Windows Hardware Compatibility
Publisher. This is required for installation on Win 7.
are signed by Microsoft Windows Hardware Compatibility
Publisher. This is required for installation on Win 7.
Note:
The Fluke 190 Series II instrument requires two
drivers to be loaded in sequence.
− 1
drivers to be loaded in sequence.
− 1
st
it requires installation of the Fluke 190
ScopeMeter USB driver
− 2
nd
it requires installation of the Fluke USB
Serial port
Both of these drivers need to be installed to be
able to communicate with the ScopeMeter!
able to communicate with the ScopeMeter!