Atmel SAM4S Xplained Pro Starter and Evaluation Kit ATSAM4S-XPRO ATSAM4S-XPRO Fiche De Données
Codes de produits
ATSAM4S-XPRO
303
SAM4S Series [DATASHEET]
Atmel-11100G-ATARM-SAM4S-Datasheet_27-May-14
16.6.2 RTC Mode Register
Name:
RTC_MR
Address:
0x400E1464
Access:
Read
/Write
This register can only be written if the WPEN bit is cleared in the System Controller Write Protection Mode Register
(SYSC_WPMR).
• HRMOD: 12-/24-hour Mode
0: 24-hour mode is selected.
1: 12-hour mode is selected.
1: 12-hour mode is selected.
• PERSIAN: PERSIAN Calendar
0: Gregorian calendar.
1: Persian calendar.
1: Persian calendar.
• NEGPPM: NEGative PPM Correction
0: Positive correction (the divider will be slightly lower than 32768).
1: Negative correction (the divider will be slightly higher than 32768).
Refer to CORRECTION and HIGHPPM field descriptions.
1: Negative correction (the divider will be slightly higher than 32768).
Refer to CORRECTION and HIGHPPM field descriptions.
• CORRECTION: Slow Clock Correction
0: No correction
1..127 = The slow clock will be corrected according to the formula given below in HIGHPPM description.
1..127 = The slow clock will be corrected according to the formula given below in HIGHPPM description.
• HIGHPPM: HIGH PPM Correction
0: Lower range ppm correction with accurate correction.
1: Higher range ppm correction with accurate correction.
If the absolute value of the correction to be applied is lower than 30 ppm, it is recommended to clear HIGHPPM. HIGHPPM
1: Higher range ppm correction with accurate correction.
If the absolute value of the correction to be applied is lower than 30 ppm, it is recommended to clear HIGHPPM. HIGHPPM
set to 1 is recommended for 30 ppm correction and above.
Formula:
If HIGHPPM = 0, then the clock frequency correction range is from 1.5 ppm up to 98 ppm. The RTC accuracy is less
than 1 ppm for a range correction from 1.5 ppm up to 30 ppm..
than 1 ppm for a range correction from 1.5 ppm up to 30 ppm..
The correction field must be programmed according to the required correction in ppm; the formula is as follows:
31
30
29
28
27
26
25
24
–
–
TPERIOD
–
THIGH
23
22
21
20
19
18
17
16
–
OUT1
–
OUT0
15
14
13
12
11
10
9
8
HIGHPPM
CORRECTION
7
6
5
4
3
2
1
0
–
–
–
NEGPPM
–
–
PERSIAN
HRMOD
CORRECTION
3906
20
ppm
×
-----------------------
1
–
=