Atmel SAM4S Xplained Pro Starter and Evaluation Kit ATSAM4S-XPRO ATSAM4S-XPRO Fiche De Données
Codes de produits
ATSAM4S-XPRO
SAM4S Series [DATASHEET]
Atmel-11100G-ATARM-SAM4S-Datasheet_27-May-14
454
Figure 26-13. Chip Select Wait State between a Read Access on NCS0 and a Write Access on NCS2
26.10.2 Early Read Wait State
In some cases, the SMC inserts a wait state cycle between a write access and a read access to allow time for the
write cycle to end before the subsequent read cycle begins. This wait state is not generated in addition to a chip
select wait state. The early read cycle thus only occurs between a write and read access to the same memory
device (same chip select).
An early read wait state is automatically inserted if at least one of the following conditions is valid:
An early read wait state is automatically inserted if at least one of the following conditions is valid:
if the write controlling signal has no hold time and the read controlling signal has no setup time (
in NCS write controlled mode (WRITE_MODE = 0), if there is no hold timing on the NCS signal and the
NCS_RD_SETUP parameter is set to 0, regardless of the read mode (
). The write operation
must end with a NCS rising edge. Without an Early Read Wait State, the write operation could not complete
properly.
in NWE controlled mode (WRITE_MODE = 1) and if there is no hold timing (NWE_HOLD = 0), the feedback
of the write control signal is used to control address, data, and chip select lines. If the external write control
signal is not inactivated as expected due to load capacitances, an Early Read Wait State is inserted and
address, data and control signals are maintained one more cycle. See
.
A[23:0]
NCS0
NRD_CYCLE
Chip Select
Wait State
NWE_CYCLE
MCK
NCS2
NRD
NWE
D[7:0]
Read to Write
Wait State