Atmel ATSTK600 500 Starter Kit and Development System. ATSTK600 ATSTK600 Fiche De Données

 

8133A-AVR-04/08 

 

The XPROG commands are described in the following section. The offsets indicated 
are offsets in the XPROG part of the CMD_XPROG command. To find the absolute 
offset in the STK600 command, add one. 

This command enables programming mode in the device by enabling the 
programming interface hardware and sending the programming key. 

Note: Before using this instruction, the programming interface (PDI or JTAG) must 
have been set by the programmer specific ‘set mode’ command. 

Table 9-5. Command format. 

0 Command 

ID

(1)

 1 

byte 

XPRG_ENTER_PROGMODE 

Notes: 

1.  The command identifier 

 

Table 9-6. Answer format. 

0 Command 

ID

(1)

 1 

byte 

XPRG_ENTER_PROGMODE 

1 Status

(2)

 1 

byte 

 

Notes: 

1.  The command identifier. 

2.  One of the defined error codes. 

 

This command leaves the device’s programming mode by clearing the reset flags and 
disabling the programming interface in hardware. 

Table 9-7. Command format. 

0 Command 

ID

(1)

 1 

byte 

XPRG_LEAVE_PROGMODE 

Notes: 

1.  The command identifier 

 

Table 9-8. Answer format. 

0 Command 

ID

(1)

 

1 byte 

XPRG_ LEAVE _PROGMODE 

1 Status

(2)

 1 

byte 

 

Notes: 

1.  The command identifier. 

2.  XPRG_ERR_OK indicates success. 

 

In order to work correctly, some parameters must be set in the programmer. Use the 
following command to initialize the XPROG interface: