Mikroelektronika MikroE Development Kits MIKROE-1435 Fiche De Données

     

1. Introduction

Once you have soldered the headers your 
board is ready to be placed into desired 
mikroBUS

™

 socket. Make sure to align the 

cut in the lower-right part of the board 
with the markings on the silkscreen at 
the mikroBUS

™

 socket. If all of the pins are 

aligned correctly, push the board all 

the way into the socket.

3. Plugging the board in

2

3

2. Soldering the headers

1

4. Essential features

Turn the board upward again. Make sure 
to align the headers so that they are 
perpendicular to the board, then solder the 
pins carefully.

Turn the board upside down so that 
bottom side is facing you upwards. 
Place shorter pins of the header into the 
appropriate soldering pads.

Before using your click

™

 board, make sure 

to solder 1x8 male headers to both left 
and right side of the board. Two 1x8 male 
headers are included with the board in 
the package.

click

BOARD

www.mikroe.com

ccRF click Manual

0 100000 023952

ccRF click

™

 is an accessory board in 

™

 form factor. It’s a compact and 

easy solution for adding RF transceiver to 
your design. It features 

 Low-Power 

2.4 GHz RF transceiver as well as PCB 
trace antenna. ccRF click

™

 communicates 

with the target board microcontroller via 

™ 

SPI (MOSI, MISO, SCK, CS), RST 

and PWM lines. The board is designed to 
use 3.3V power supply only. LED diode 
(GREEN) indicates the presence of power 
supply.

ccRF 

click

ccRF click

™

 with it’s 

IC is a low-power 

2.4 GHz transceiver designed for the 2400-
2483.5 MHz ISM and SRD frequency band. 
The 

is integrated with a highly 

configurable baseband modem that supports 
various modulation formats and has data rate 
up to 500 kBaud. All these features make 
this board ideal for consumer electronics, 
wireless audio, wireless keyboard and mouse 
RF remote controls and many more.