Atmel Xplained Evaluation Board AT32UC3A3-XPLD AT32UC3A3-XPLD Fiche De Données
Codes de produits
AT32UC3A3-XPLD
1004
32072H–AVR32–10/2012
AT32UC3A3
After these commands, read 3 times one flash page initialized to 00h. Disable the flash high
speed mode (FLASHC HSDIS command). It is then possible to safely read or code fetch the
flash.
speed mode (FLASHC HSDIS command). It is then possible to safely read or code fetch the
flash.
39.3
Rev. D
39.3.1
General
Devices cannot operate with CPU frequency higher than 66MHz in 1WS and 36MHz in
0WS
Fix/Workaround
None
0WS
Fix/Workaround
None
DMACA data transfer fails when CTLx.SRC_TR_WIDTH is not equal to
CTLx.DST_TR_WIDTH
Fix/Workaround
For any DMACA transfer make sure CTLx.SRC_TR_WIDTH = CTLx.DST_TR_WIDTH.
CTLx.DST_TR_WIDTH
Fix/Workaround
For any DMACA transfer make sure CTLx.SRC_TR_WIDTH = CTLx.DST_TR_WIDTH.
3.3V supply monitor is not available
FGPFRLO[30:29] are reserved and should not be used by the application.
Fix/Workaround
None.
FGPFRLO[30:29] are reserved and should not be used by the application.
Fix/Workaround
None.
Service access bus (SAB) can not access DMACA registers
Fix/Workaround
None.
Fix/Workaround
None.
Processor and Architecture
LDM instruction with PC in the register list and without ++ increments Rp
For LDM with PC in the register list:
the instruction behaves as if the ++ field is always set, ie
the pointer is always updated. This happens even if the ++ field is cleared. Specifically, the
increment of the pointer is done in parallel with the testing of R12.
increment of the pointer is done in parallel with the testing of R12.
Fix/Workaround
None.
None.
Hardware breakpoints may corrupt MAC results
Hardware breakpoints on MAC instructions may corrupt the destination register of the MAC
instruction.
Fix/Workaround
Place breakpoints on earlier or later instructions.
Hardware breakpoints on MAC instructions may corrupt the destination register of the MAC
instruction.
Fix/Workaround
Place breakpoints on earlier or later instructions.
When the main clock is RCSYS, TIMER_CLOCK5 is equal to PBA clock
When the main clock is generated from RCSYS, TIMER_CLOCK5 is equal to PBA Clock
and not PBA Clock / 128.
Fix/Workaround
None.
When the main clock is generated from RCSYS, TIMER_CLOCK5 is equal to PBA Clock
and not PBA Clock / 128.
Fix/Workaround
None.
RETE instruction does not clear SREG[L] from interrupts
The RETE instruction clears SREG[L] as expected from exceptions.
Fix/Workaround
When using the STCOND instruction, clear SREG[L] in the stacked value of SR before
returning from interrupts with RETE.
The RETE instruction clears SREG[L] as expected from exceptions.
Fix/Workaround
When using the STCOND instruction, clear SREG[L] in the stacked value of SR before
returning from interrupts with RETE.