Mikroelektronika MikroE Development Kits MIKROE-1196 Fiche De Données
Codes de produits
MIKROE-1196
1. Introduction
Once you have soldered the headers your
board is ready to be placed into desired
mikroBUS™ socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at the
mikroBUS™ socket. If all of the pins are
board is ready to be placed into desired
mikroBUS™ socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at the
mikroBUS™ socket. If all of the pins are
aligned correctly, push the board all
the way into the socket.
3. Plugging the board in
2
3
2. Soldering the headers
1
4. Essential features
Turn the board upward again. Make sure
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
Turn the board upside down so that
bottom side is facing you upwards. Place
shorter parts of the header pins in both
soldering pad locations.
bottom side is facing you upwards. Place
shorter parts of the header pins in both
soldering pad locations.
Opto
click
Before using your click board™, make sure
to solder 1x8 male headers to both left
and right side of the board. Two 1x8 male
headers are included with the board in
the package.
to solder 1x8 male headers to both left
and right side of the board. Two 1x8 male
headers are included with the board in
the package.
click
BOARD
www.mikroe.com
Opto click Manual
ver. 1.00
0 100000 020999
Opto Click™ with it’s DIP
VO2630
modules
results in support for high speed (10 Mbd)
between it’s input and output with galvanic
isolation. It has common mode transient
immunity of 100 V/μs and low input current
capability of 5 mA. All these features make
this board ideal for PLC and ATE I/O isolation,
high speed A/D and D/A conversion, Digital
control power supply, computer peripherals,
microprocessor interface and more.
between it’s input and output with galvanic
isolation. It has common mode transient
immunity of 100 V/μs and low input current
capability of 5 mA. All these features make
this board ideal for PLC and ATE I/O isolation,
high speed A/D and D/A conversion, Digital
control power supply, computer peripherals,
microprocessor interface and more.
Opto Click™ is an accessory board in
mikroBUS™
form factor. It’s a compact
solution for adding electrical isolation be-
tween inputs and outputs to your device. It
features two DIP
tween inputs and outputs to your device. It
features two DIP
VO2630
dual channel, high
speed optocoupler modules. Opto Click™
communicates with target board via four
communicates with target board via four
mikroBUS™
lines (INT, CS, RST, AN). The
board is designed to use 3.3V and 5V power
supply.
supply.
It has six screw terminals for easy
connection and a LED diode (GREEN) that
indicates the presence of power supply.
indicates the presence of power supply.