Olimex 4.3'' LCD screen with backlight and resistive touch screen panel, compatible with A13-OLinuXino and iMX233-OLinuXino Oli A13-LCD43TS Fiche De Données
Codes de produits
A13-LCD43TS
OLIMEX© 2012
A13-OLinuXino user's manual
CHAPTER 1: OVERVIEW
1. Introduction to the chapter
Thank you for choosing the OLinuXino single board computer from Olimex! This document
provides a user’s guide for the Olimex OLinuXino board. As an overview, this chapter gives the
scope of this document and lists the board’s features. The document’s organization is then detailed.
The OLinuXino development board enables code development of applications running on the
microcontroller A13, manufactured by Allwinner Technology from China.
provides a user’s guide for the Olimex OLinuXino board. As an overview, this chapter gives the
scope of this document and lists the board’s features. The document’s organization is then detailed.
The OLinuXino development board enables code development of applications running on the
microcontroller A13, manufactured by Allwinner Technology from China.
OLinuXino is an open-source, open-hardware project and all documentation is available to the
customer.
customer.
1.1 Features
•
A13 Cortex A8 processor at 1GHz, 3D Mali400 GPU
•
512 MB RAM
•
6-16VDC input power supply, noise immune design
•
3 + 1 USB Host, 3 available for users 1 for (optional) WIFI RTL8188CU 802.11n 150Mbit
module on board
module on board
•
1 USB OTG which can power the board
•
SD-card connector for booting the Linux image
•
(optional) 4GB NAND flash
•
VGA video output – 800 x 600 resolution
•
LCD signals available on connector so you still can use LCD if you diasble VGA/HDMI
•
Audio Output
•
Microphone input
•
RTC PCF8536 on board for real time clock and alarms
•
5 Keys on board for android navigation
•
UEXT connector for connecting addtional UEXT modules like Zigbee, Bluetooth, Relays,
etc
etc
•
GPIO connector with 68/74 pins and these signals : 17 for adding NAND flash; 22 for
connecting LCDs; 20+4 including 8 GPIOs which can be input, output, interrupt sources; 3x
I2C; 2x UARTs; SDIO2 for connectinf SDcards and modules; 5 system pins: +5V, +3.3V,
GND, RESET, NMI
connecting LCDs; 20+4 including 8 GPIOs which can be input, output, interrupt sources; 3x
I2C; 2x UARTs; SDIO2 for connectinf SDcards and modules; 5 system pins: +5V, +3.3V,
GND, RESET, NMI
•
(Optional low cost 7" LCD with touchscreen)
Page 5 of 37