Secutech Radio modules ST002002 Fiche De Données
Codes de produits
ST002002
Page 24
Security & Electronic Technologies GmbH
Putting into service a SECU-DATA 42xx
1. Connect the probes and the evaluation equipment to the SECU-
DATA 42xx units
2. Turn on the DC power supply
in the range of +11 V … +40 V
3. Match
one
pair
of
instruments
together:
Set the same channel block number on both instruments
– factory
default is block #6
– details se chapter Settings-Selection of the
RF-channel
block
Match the instruments together
– detail see chapter Settings-
Matching two SECU-DATA xxxx
4. Both SECU-DATA 42xx modules will establish an RF-inter-
connection immediately, the green RF-indicators are blinking. After
some seconds they are continuously on
some seconds they are continuously on
– the connection is active.
5. The current on the input of the SECU-DATA 42xM is reproduced
precisely on the output of the SECU-DATA 42xC / 142xC for evalu-
ation with the controller equipment.
ation with the controller equipment.
6. Check the current values on the evaluation instrument for
plausibility.
The commissioning is completed now successfully.