STMicroelectronics Discovery kit for STM32L100 Value line - with STM32L100RC MCU STM32L100C-DISCO STM32L100C-DISCO Fiche De Données
Codes de produits
STM32L100C-DISCO
DocID025091 Rev 1
UM1656
Hardware and layout
29
4.2 Embedded
ST-LINK/V2
The ST-LINK/V2 programming and debugging tool is integrated on the
32L100CDISCOVERY. The embedded ST-LINK/V2 can be used in 2 different ways
according to the jumper states (see
32L100CDISCOVERY. The embedded ST-LINK/V2 can be used in 2 different ways
according to the jumper states (see
):
•
Program/debug the MCU on board,
•
Program/debug an MCU in an external application board using a cable connected to
SWD connector CN3.
SWD connector CN3.
The embedded ST-LINK/V2 supports only SWD for STM32 devices. For information about
debugging and programming features refer to user manual UM1075 (ST-LINK/V2 in-circuit
debugger/programmer for STM8 and STM32) which describes in detail all the ST-LINK/V2
features.
debugging and programming features refer to user manual UM1075 (ST-LINK/V2 in-circuit
debugger/programmer for STM8 and STM32) which describes in detail all the ST-LINK/V2
features.
Figure 7. Typical configuration
Table 2. Jumper states
Jumper state
Description
Both CN2 jumpers ON
ST-LINK/V2 functions enabled for on board programming (default)
Both CN2 jumpers OFF
ST-LINK/V2 functions enabled for application through external CN3
connector (SWD supported)
connector (SWD supported)
-36
(ARDWARE
$EVELOPMENT