Conrad Energy remote control ARF 2320 mm FMS023 Fiche De Données

•  Before commissioning, check the trim lever settings at the transmitter for direction control and adjust them if 

required.  

•  Always check the correct and secure position of the propeller before operation.
•  Make sure that no objects, clothes or body parts are in the range or the suction area of the rotors while they are 

rotating.

•  Do not take any risks when operating the product! Your own safety and that of your environment depends comple-

tely on your responsible use of the model.

•  Improper operation can cause serious damage to people and property! Therefore make sure to keep a sufficiently 

safe distance to persons, animals or objects during operation. 

•  Select a suitable flight room to operate your model. We recommend choosing a windstill or low-wind day for your 

first flights.

•  Only fly your model if your ability to react is unlimited. The influence of tiredness, alcohol or medication can cause 

incorrect responses.

•  Do not fly directly towards audience or yourself.
•  Motor, flight controller and flight battery may heat up during operation of the model. For this reason, wait for 5 to 

10 minutes before recharging or replacing the flight battery. The drive motor must have cooled down to ambient 

temperature. 

•  As long as the model is in operation you must always leave the transmitter switched on. After landing, always 

disconnect the flight battery from the model first. Only then may the transmitter be switched off.

•  In case of defect or malfunction, remove the cause of the interference before starting your model again.
•  Never expose your model or the transmitter to direct sunlight or excessive heat for an extended period of time.
•  After use, the flight battery must be disconnected from the model and the transmitter switched off.