Conrad Energy remote control ARF 2320 mm FMS023 Fiche De Données

Install the rudder horn at the elevator as shown symbolically in figure 2, items 1 and 2. 
For this, insert the rudder horn into the underside of the elevator in the prefabricated indentation (1) and screw them 

to the counterplate (2) at the rudder.
Use one screw 1.6 x 10 mm each at the turning point of the rudder and one screw 1.6 x 8 mm at the rear edge of 

the rudder.

  Install the rudder horns to the rudder flaps of the wings and the rudder in the same manner as shown for 

the elevators. However, use ball joint rudder horns for this (figure 2. items 3 and 4).

 

For this, insert the rudder horns into the prefabricated indentations in the rudder flaps of the wings (at the 

bottom of the rudder flaps) and screw them to the respective rudder with a counterplate. For assembly of 

the rudder horn at the rudder, use figure 4 for reference.

 

Use one screw 1.6 x 10 mm each at the turning point of the rudder and one screw 1.6 x 8 mm at the rear 

edge of the rudder.