Robbe Arcus 1-2592 Fiche De Données

4

-  The illustration shows both V-tail halves with the hard pla-

stic joiner prior to assembly.

-  Finally fix the tailplane to the fuselage using the supplied 

screws inserted from below and thread the pushrods into 
the openings in the control horns. Dont screw the push-

-  Set the servo to centre (neutral) using the transmitter. 
  You can install a second optional servo for the rudder func-

tion if desired (see marking). If using this option, the V-tail 
mixer must be used in your radio.

-  Check the servo neutrals once more. The servo arm must be 

at right angles to the servo.

  Now you can permanently screw the pushrod to the control 

horns.

- Using 

Ropoxi 5-minute epoxy, glue both V-tail halves to the 

hard plastic joiner.Allow the glue joint to harden.

-  Place the  V-tail unit into the opening in the fuselage. The 

hard plastic joiner guide spigot must be inserted into the 
guide tube in fuselage. Reinforce the tail to fuselage joint 
with a 50 mm long strip of Tesa adhesive tape (see small 
illustration on right)