Mc Crypt LED bar No. of LEDs: 320 LB320 LB320 Fiche De Données
Codes de produits
LB320
26
8. Installation
Assembly and installation of the device must be carried out by a specialist familiar with the hazards
and the relevant regulations. Maintenance, operation and commissioning of this device must only
be carried out by qualified persons.
When choosing a location for your device, make sure to avoid impact, vibration, dust, hot and
cold temperatures and dampness. Furthermore, no powerful transformers or motors must be used
close to the device.
Never cover the device. Ensure sufficient ventilation when setting up the device with other equip-
ment. Maintain a sufficient distance to other devices and walls. Never put up the effect light in
direct proximity of heat sources. Do not point any strong spotlights or light sources towards the
device. This may cause overheating (danger of fire!).
Do not drill or screw additional screws into the casing in order to fasten the device. This may
expose dangerous voltage to touch.
The device must be mounted out of normal reach.
Illuminated objects must be at least 1 m away from the device‘s light emission source. Easily
flammable materials like decorative fabrics must have a distance of at least 0.5 m from the device.
Otherwise, such objects may catch fire!
When mounting the product, make sure that the power cord is neither jammed nor damaged by
sharp edges.
During installation or service work, the area below the place of installation must be cordoned
off.
The installation surface or mounting fixture needs to be designed in a way that it can take 10 times
its load capacity for at least 1 hour without permanent damaging deformation.
It is also essential that the device is secured by means of a second safety restraint that is inde-
pendent of the actual mounting supports when installing it in an elevated position. No part of the
installation must fall down if the main suspension system fails.
Observe all relevant regulations of your country when mounting/installing the device.
Acceptance test (in case of industrial/public use):
Before first use and after any significant modifications, the installation (including the electrical connec-tions)
must be inspected by an official expert.
A yearly inspection by an expert is required.
• Install the effect beamer on the ceiling, the wall or a suitable crossbeam with the mounting angles. The assembly must
never swing freely. Use assembly material suitable for the assembly area and for bearing the effect light load.
• Additionally secure the installation with a suitable safety restraint cable or a safety net. The safety retention rope or
the net must be designed to support the effect light in the event of failure of the main support system independently
of the main attachment.
• Set the desired inclination angle and tighten the wing screws to the assembly angles well.