Conrad 393904 time 393904 Fiche De Données
Codes de produits
393904
4
2. General Information
• This PC software may be used to configure different switching functions as well as logical operations of the inputs.
• In the delivery condition, the operating mode „Power surge switch“ is preset.
• Data transfer to the multifunction timer is performed via the Voltcraft USB programming cable (Conrad item no. 197339).
• The data interface serves only parameter transmission. It must not be connected to a computer during operation.
The PC software is available free of charge at www.conrad.com in the download area for the „MFT1816“ (supported operating systems: Windows
XP and higher)
XP and higher)
VCC
Set
Reset
J2
μ C
J3
CO
M
NO
NC
ST
AT
REL
SEQ
SET
RES
R3
VCC
GND
SET
SET
RESET
RESET
SEQ
GND
SET
SET
RESET
RESET
SEQ
J4
1
2
3
4
5
6
7
GND
J1
Optocoupler inputs (polarity does not
matter), switching, e.g, via buttons
matter), switching, e.g, via buttons
J3: Connection of the Voltcraft
USB programming cable
USB programming cable
R3: Potentiometer (selection of the
operating mode or time setting)
operating mode or time setting)
Timer time 10 s.....30 min
(0....98% rotating range)
(0....98% rotating range)
PC mode (98....100% rotating area)
The Voltcraft USB-programming cable (Conrad item no. 197339) is needed for data transfer. It must be connected to the J3-connection
of the multifunction timer.
of the multifunction timer.
Configuration by PC-software is performed in the potentiometer range of 98…100% (display by flashing LED „STAT“).
Switching of an input is explained in these operating instructions using the illustrated buttons. A pushed button is defined as a positive
level. Since these are optocoupler inputs, only one current flow is decisive for switching. The polarity is irrelevant for this.
level. Since these are optocoupler inputs, only one current flow is decisive for switching. The polarity is irrelevant for this.